QB Wings: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
mNo edit summary |
||
| Line 1: | Line 1: | ||
* The QB wings come with 2 x CM-4M bearings. This is the right amount as the other 2 needed for the flaps (page 44-5) are part of the fuselage kit according to Vans. | * The QB wings come with 2 x CM-4M bearings. This is the right amount as the other 2 needed for the flaps (page 44-5) are part of the fuselage kit according to Vans. | ||
*A builder observed that the bolts holding the tank were one size too long which was compensated by using 5 washers which is above the 3 washer limit set by the FAA. | *A builder observed that the bolts holding the tank were one size too long which was compensated by using 5 washers which is above the 3 washer limit set by the FAA. | ||
* See this [https://www.facebook.com/groups/vansrv10/posts/5947324302055286/ FB thread] about how to run pitot tubes / cables through QB-wings. | |||
Latest revision as of 16:27, 1 April 2023
- The QB wings come with 2 x CM-4M bearings. This is the right amount as the other 2 needed for the flaps (page 44-5) are part of the fuselage kit according to Vans.
- A builder observed that the bolts holding the tank were one size too long which was compensated by using 5 washers which is above the 3 washer limit set by the FAA.
- See this FB thread about how to run pitot tubes / cables through QB-wings.