SECTION 40: FLAP SYSTEM: Difference between revisions
Jump to navigation
Jump to search
mNo edit summary |
m (Bellcrank jig comment) |
||
| Line 4: | Line 4: | ||
Check for more recent updates [https://www.vansaircraft.com/service-information-and-revisions/?aircraft=rv-10&doctype=revisions-changes&sort=date here] | Check for more recent updates [https://www.vansaircraft.com/service-information-and-revisions/?aircraft=rv-10&doctype=revisions-changes&sort=date here] | ||
=== Hints === | === Hints === | ||
==== Page 40-3 Bellcrank jig ==== | |||
* The bellcrank jig comes in the wing kit and at this point you may have possibly misplaced it. The measurement from the bottom of the jig to the 1/4 inch hole shown in Figure 2 is 1 & 31/32 inch if you want to make your own. | |||
==== Page 40-4 ==== | ==== Page 40-4 ==== | ||
* Step 4: See [[ | * Step 4: See [[index.php?title=Media:Flapbush.pdf|this pdf]] with 4 templates for the cutout with rounding radiuses applied. Print at 100%. The outer corner dimensions on the printout should be 2.5" * 1.75". | ||
==== Flap Position Sensor ==== | ==== Flap Position Sensor ==== | ||
* The old flap motor (before mid 2022) has no built-in position sensor and needs an external POS-12 sensor. See section [[Flap_Position_Sensor]] | * The old flap motor (before mid 2022) has no built-in position sensor and needs an external POS-12 sensor. See section [[Flap_Position_Sensor]] | ||
[[Category:Hints]] | [[index.php?title=Category:Hints]] | ||
Revision as of 15:06, 12 December 2024
Build Instruction Updates
Check for more recent updates here
Hints
Page 40-3 Bellcrank jig
- The bellcrank jig comes in the wing kit and at this point you may have possibly misplaced it. The measurement from the bottom of the jig to the 1/4 inch hole shown in Figure 2 is 1 & 31/32 inch if you want to make your own.
Page 40-4
- Step 4: See this pdf with 4 templates for the cutout with rounding radiuses applied. Print at 100%. The outer corner dimensions on the printout should be 2.5" * 1.75".
Flap Position Sensor
- The old flap motor (before mid 2022) has no built-in position sensor and needs an external POS-12 sensor. See section Flap_Position_Sensor