SECTION 36: BRAKE LINES: Difference between revisions
Jump to navigation
Jump to search
m (→Page 36-2) |
m (→Page 36-2) |
||
| Line 6: | Line 6: | ||
==== Page 36-2 ==== | ==== Page 36-2 ==== | ||
* Step 2 - The hole in the landing gear mount might need to be enlarged a bit to 7/16 to make the elbow fitting go through. Works best with a 7/16 reamer (e.g. $21 at [https://www.yardstore.com/reamer-chucking-7-16 Yardstore]). | * Step 2 - The hole in the landing gear mount might need to be enlarged a bit to 7/16 to make the elbow fitting go through. Works best with a 7/16 reamer (e.g. $21 at [https://www.yardstore.com/reamer-chucking-7-16 Yardstore]).<br>The elbow fitting doesn't quite stick out enough to get a wrench on it when torquing the nuts. Consider adding a AN960-716 / NAS1149F0763 washer sneaked in between the bottom skin and the weldment so that the washer sits between the fitting and the weldment on the bottom side. | ||
* Figure 2 - If you have a return fuel line (e.g. SDS electronic injection), the brake line goes into the aft of the 3 holes, not the center hole as illustrated in figure 2. | * Figure 2 - If you have a return fuel line (e.g. SDS electronic injection), the brake line goes into the aft of the 3 holes, not the center hole as illustrated in figure 2. | ||
[[Category:Hints]] | [[Category:Hints]] | ||
Revision as of 21:28, 20 January 2024
Build Instruction Updates
- N/A
Check for more recent updates here
Hints
Page 36-2
- Step 2 - The hole in the landing gear mount might need to be enlarged a bit to 7/16 to make the elbow fitting go through. Works best with a 7/16 reamer (e.g. $21 at Yardstore).
The elbow fitting doesn't quite stick out enough to get a wrench on it when torquing the nuts. Consider adding a AN960-716 / NAS1149F0763 washer sneaked in between the bottom skin and the weldment so that the washer sits between the fitting and the weldment on the bottom side. - Figure 2 - If you have a return fuel line (e.g. SDS electronic injection), the brake line goes into the aft of the 3 holes, not the center hole as illustrated in figure 2.