SECTION 8: HORIZONTAL STABILIZER: Difference between revisions
Jump to navigation
Jump to search
mNo edit summary |
mNo edit summary |
||
| Line 2: | Line 2: | ||
* 10/05/21 [https://www.vansaircraft.com/wp-content/uploads/2021/10/08_10.pdf 08_10.pdf] | * 10/05/21 [https://www.vansaircraft.com/wp-content/uploads/2021/10/08_10.pdf 08_10.pdf] | ||
Check for more recent updates [https://www.vansaircraft.com/service-information-and-revisions/?aircraft=rv-10&doctype=revisions-changes&sort=date here] | Check for more recent updates [https://www.vansaircraft.com/service-information-and-revisions/?aircraft=rv-10&doctype=revisions-changes&sort=date here] | ||
=== Before You Start === | |||
Special/New Tools/Supplies | |||
* You will need to build some wooden support braces (see page 8-7, step 5). | |||
==== Page 8-3 ==== | ==== Page 8-3 ==== | ||
Revision as of 00:53, 23 February 2025
Build Instruction Updates
- 10/05/21 08_10.pdf
Check for more recent updates here
Before You Start
Special/New Tools/Supplies
- You will need to build some wooden support braces (see page 8-7, step 5).
Page 8-3
- Step3: The 1 21/32 lower flange width dimension is to be applied at the 1 inch line, not at 2 inches, the raw angle size.
Page 8-7
- Step 3: only cut back the two corners on the front edge of the nose rib, not the entire edge because then you will violate the edge distance for the foremost rivet. See also this FB thread.
- Step 4: Very likely that the nose rib that came with a recent kit already has the holes in the web that step 4 calls out for making