3D-Printed Tools and Parts

• Les Kearney's Collection
• Allan's wing conduit and pitot line bracket
  • STL File with pitot
  • STL File without pitot
• Shawn's wing conduit and pitot line bracket
• FB thread on printing wing conduit brackets
• Oil Cap with center hole for engine dehumidifier
• Conduit holder with variable tilt angle
• Front RV-10 vent plug
• Glareshield strut compass holder (stl file), credit Igor, VAF member supik
• Consider joining the 3D Printed Aircraft Parts FB group.
• FB thread on avionics fan controller enclosure
  Fan controller enclosure V1.stl
  Fan controller lid V1.stl
• Current Sensor mount by Rodrigo
  
  • Mount - Part 1
  • Mount - Part 2
• Current Sensor mount for AWG 2 cable by Martin. Uses 3 cable ties to hold the parts and cable together.
  Onshape Project: current_sensor_mount
  
  • Mount - Part 1
  • Mount - Part 2
  • Mount - Part 3

• End cap for armrest
  
  
  End Cap stl file
• Door hinge alignment jig. Print 2 of these and snap them to the bottom of WD-1018 in lieu of the three .125 scrap aluminum pieces for spacing (see 45-06 step #3).

Door alignment jig

Hinge alignment jig STL file