SECTION 15: REAR SPAR: Difference between revisions
Jump to navigation
Jump to search
m (→Page 15-5) |
m (→Page 15-4) |
||
| Line 17: | Line 17: | ||
=== Page 15-4 === | === Page 15-4 === | ||
* W-1007D Rear Spar Doubler Plate<br>Vans had a batch of this part being too long. See also this [https://www.facebook.com/groups/794208517366916] | * W-1007D Rear Spar Doubler Plate<br>Vans had a batch of this part being too long. See also this [https://www.facebook.com/groups/794208517366916 FB thread]. | ||
=== Page 15-5 === | === Page 15-5 === | ||
* Step 1: Match-drilling 4 of the W-1007B holes on the fork's arms create new holes in the flanges of the W-1010-L/R ribs as they don't align with the existing holes in the rib flanges<br>[[File:2022-05-28 15-14-05.jpg|600x600px]]<br> <br>[[File:2022-05-28 15-13-41.jpg|600x600px]] | * Step 1: Match-drilling 4 of the W-1007B holes on the fork's arms create new holes in the flanges of the W-1010-L/R ribs as they don't align with the existing holes in the rib flanges<br>[[File:2022-05-28 15-14-05.jpg|600x600px]]<br> <br>[[File:2022-05-28 15-13-41.jpg|600x600px]] | ||
Latest revision as of 05:41, 24 April 2026
Build Instruction Updates
- 10/05/21 15_10.pdf
Check for more recent updates here
Videos
Hints
Page 15-2
(FB 3/20/2022) Aileron bracket errors[Ed: this page isn't very useful, as you have to be a member and logged into Facebook to see it)
YES, all the FB links assume you are a member of the two RV-10 groups: RV-10 (4,700 members) and Van's RV-10 (420 members).
Page 15-3
- Step 3: You are asked to draw a single line along the sloped edge of W-1013D-L/R. You ignore the top horizontal edge of W-1013D-L/R. So W-1013F-L/R will only have a corner trimmed off, you are not shortening the angle in height. See also this FB thread.
Page 15-4
- W-1007D Rear Spar Doubler Plate
Vans had a batch of this part being too long. See also this FB thread.
Page 15-5
- Step 1: Match-drilling 4 of the W-1007B holes on the fork's arms create new holes in the flanges of the W-1010-L/R ribs as they don't align with the existing holes in the rib flanges
- Step 4: Note that there are no AN470AD4-7 rivets called out in Figure 2 even though it is listed in the legend.
- Read through the Service Bulletin SB-16-03-28 to better understand the assembly (ignore the drill-out instructions).
- See also FB post 6/9/2022
